The Host Dos Protection - ZyXEL Communications MES-2110 User Manual

Intelligent layer 2 switch
Hide thumbs Also See for MES-2110:
Table of Contents

Advertisement

20.8 The Host DoS Protection

You can specify a group of one or more "trusted computers" from which an
administrator may use a service to manage the Switch. When you turn on this
feature, only the trusted IP addresses listed in this screen can use remote
management to access the Switch. Click Mgmt Config > Host Denial-of-
Service Protection to open the following screen.
Figure 86 Mgmt Config > Host Denial-of-Service Protection
The following table describes the labels in this screen.
Table 69 Mgmt Config > Host Denial-of-Service Protection
LABEL
Protection
IP Address
Enable/Disable
Undo
Apply
MES-2110 User's Guide
Chapter 20 Mgmt Config and System Restart Menu
DESCRIPTION
Use this to enable or disable host denial-of-service protection.
Configure the IP address of the trusted computer from which you
can manage this Switch.
The Switch checks if the client IP address of a computer
requesting a service or protocol matches the range set here. The
Switch immediately disconnects the session if it does not match.
Select Enable to activate this secured client set.
Select Disable if you wish to temporarily disable the set without
deleting it.
Click this to restore your last saved settings.
Click this to save your changes.
153

Advertisement

Table of Contents
loading

Table of Contents