Arp Inspection Log Status - ZyXEL Communications GS 2200 Manual

Chapter 25 IP Source Guard
Table 74 ARP Inspection VLAN Status
LABEL
Request
Reply
Forwarded
Dropped

25.8 ARP Inspection Log Status

Use this screen to look at log messages that were generated by ARP packets and that have not
been sent to the syslog server yet. To open this screen, click Advanced Application > IP Source
Guard > ARP Inspection > Log Status.
Figure 128 ARP Inspection Log Status
The following table describes the labels in this screen.
Table 75 ARP Inspection Log Status
LABEL
Clearing log status
table
Total number of logs
Index
Port
VID
Sender MAC
Sender IP
Num Pkts
206
DESCRIPTION
This field displays the total number of ARP Request packets received from the VLAN
since the Switch last restarted.
This field displays the total number of ARP Reply packets received from the VLAN since
the Switch last restarted.
This field displays the total number of ARP packets the Switch forwarded for the VLAN
since the Switch last restarted.
This field displays the total number of ARP packets the Switch discarded for the VLAN
since the Switch last restarted.
DESCRIPTION
Click Apply to remove all the log messages that were generated by ARP packets and
that have not been sent to the syslog server yet.
This field displays the number of log messages that were generated by ARP packets
and that have not been sent to the syslog server yet. If one or more log messages are
dropped due to unavailable buffer, there is an entry called overflow with the current
number of dropped log messages.
This field displays a sequential number for each log message.
This field displays the source port of the ARP packet.
This field displays the source VLAN ID of the ARP packet.
This field displays the source MAC address of the ARP packet.
This field displays the source IP address of the ARP packet.
This field displays the number of ARP packets that were consolidated into this log
message. The Switch consolidates identical log messages generated by ARP packets in
the log consolidation interval into one log message. You can configure this interval in
the ARP Inspection Configure screen. See Section 25.9 on page 207.
GS2200-8/24 User's Guide