The Mvr Screen - ZyXEL Communications GS 2200 Manual

Chapter 23 Multicast
Table 58 Advanced Application > Multicast > Multicast Setting > IGMP Filtering Profile (continued)
LABEL
End Address
Add
Clear
Profile Name
Start Address
End Address
Delete
Cancel

23.6 The MVR Screen

Use the MVR screen to create multicast VLANs and select the receiver port(s) and a source port for
each multicast VLAN. Click Advanced Applications > Multicast > Multicast Setting > MVR link
to display the screen as shown next.
Note: You can create up to three multicast VLANs and up to 256 multicast rules on the
Switch.
176
DESCRIPTION
Type the ending multicast IP address for a range of IP addresses that you want to belong
to the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both the Start Address and
End Address fields.
Click Add to save the profile to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
This field displays the descriptive name of the profile.
This field displays the start of the multicast address range.
This field displays the end of the multicast address range.
To delete the profile(s) and all the accompanying rules, select the profile(s) that you want
to remove in the Delete Profile column, then click the Delete button.
To delete a rule(s) from a profile, select the rule(s) that you want to remove in the Delete
Rule column, then click the Delete button.
Click Cancel to clear the Delete Profile/Delete Rule check boxes.
GS2200-8/24 User's Guide