PANCONTROL PAN Allrounder 200AD Manual

Manual
PAN Allrounder 200AD
Current- / Voltage Tester
1. Introduction
Thank you for purchasing PANCONTROL. Since 1986, the PANCONTROL brand has
stood for practical, innovative and professional measuring instruments. We hope you
enjoy using your new product and we are convinced that it will serve you well for
many years to come.
Please read this operating manual carefully before using the device to become
familiar with the proper handling of the device and to prevent faulty operations.
Please follow all the safety instructions. Nonobservance cannot only result in damages
to the device but in the worst case can also be harmful to health.
2. Scope of delivery
After unpacking please check the package contents for transport damage and
completeness.
•
Measurement device
•
Test leads (with Protective cover)
•
Contact sleeves Ø 4 mm
•
Operating manual
3. Safety Instructions
To ensure the safe use of the device, please follow all the safety and operating
instructions given in this manual.
•
The device is only intended for use by qualified personnel and in accordance with
the relevant regulations for safe work on electrical systems.
•
Before using the device, make sure that test leads and the device are in good
condition and the device is working properly.
•
The device may not be used if the housing or the test leads are damaged, if one
or more functions are not working, if functions are not displayed, or if you suspect
that something is wrong.
•
If the safety of the user cannot be guaranteed, the device may not be operated
and secured against use.
•
Never connect the device to voltage or current sources that exceed the specified
maximum values.
•
Never touch conductive parts or bare wires.
•
Be careful when working on voltages above 60V DC, 30V AC (RMS) or 42V AC
(peak value). These tensions can be life-threatening!
•
Do not use the device in any higher category than allowed.
•
Perform a functional test each time the voltage tester is commissioned.
•
While using this device, hold the test leads only behind the finger guards - do not
touch the probes!
•
Never ground yourself while making electrical measurements. Do not touch any
exposed metal pipes, fittings etc., which could have a ground potential. Ensure
that your body is isolated by using dry clothes, rubber shoes, rubber mats or
other approved insulation materials.
•
Place the device in such a way that it is possible to disconnect it from the mains
at any time.
•
Before measuring currents with the pliers, remove the test cables from the
device.
•
If the battery symbol appears in the display, replace the battery immediately.
•
Always switch off the appliance and remove the test leads from all voltage
sources before opening the device to exchange the battery or the fuse.
•
Never use the device with the housing, battery or fuse compartment open.
•
Avoid voltage measuring in electrical circuits while motors are switched on or off.
The stress-spikes can damage the instrument.
•
Do not use the device near strong magnetic fields (for e.g. welding transformer),
as this can distort the display.
•
Do not use the device outdoors, in humid surroundings or in environments that
are subjected to extreme temperature fluctuations.
•
Never use the device in an explosionprone environment.
•
Do not store the device in places which are exposed to direct sunlight.
•
Remove the battery if the device is not used for a long time.
•
If changes or modifications are made to the device, the operational safety is no
longer guaranteed and the warranty becomes void.
MEnglishM