Playing A Disc - LENCO DVP-706 Owner's Manual

Playing a Disc

Preparation for Playback
1. Make sure the Player has the power either from the battery
or the AC adaptor.
2. Load a disc, following these steps:
Open the top cover.
Press the OPEN button to open the disc cover.
Place a disc into the tray with the label side facing up.
Close the disc cover.
3. Slide POWER to ON to turn on the power.
Play
Press (on the remote control) or
start play.
Adjusting volume
Press VOL+ or VOL- to change volume.
Stop
1. Press on the player to temporarily stop the playback, "
appears on the screen.
2. Press again to stop the playback.
Resume
There are two ways to resume your playback when interrupted.
Method 1. -- for short time interruption
Skip
You can skip chapters on DVD-Video, tracks on CDs, and
Video CDs.
1. To skip forward, press
(on the player) to
2. To skip to
Fast Forward and Reverse
1. During playback, to fast forward, press and hold
"
2. During playback, to fast reverse, press and hold
3. To resume normal playback, press
~ 11 ~
1. Press STOP ( ), the Player remembers where you stopped.
2. To resume, press PLAY, the Player will play from where you
stopped.
Method 2. -- for longer time interruption
1. Press OPEN to open the disc compartment door while the
Player is playing.
2. You can turn off the power, and even remove the disc from
the desk, when you turn on the power and replace the disc,
the Player will play from the point when the door was opened.
chapter or track. Each press increases the numbers of skips.
the previous chapter or track, press
player) to increase the fast forward speed 2x, then repeatedly
press to increase to 4x, 8x, 16x, 32x.You can also simply
repeatedly press on the remote control to increase the
fast forward speed.
player) to increase the fast reverse speed 2x ,then repeatedly
press to increase to 4x, 8x, 16x, 32x. You can also simply
repeatedly press on the remote control to increase the
fast reverse speed.
during play ,it skips to the next
.
(on the
(on the
.