Bowflex Max Trainer M6 Troubleshooting Manual

3/11/24, 8:29 AM
Max Trainer M6: Why is my resistance not changing?
Follow this troubleshooting guide to help resolve resistance issues on the Max Trainer M6.
Some common complaints may include:
No resistance
Resistance does not change when adjusted
Follow these steps to troubleshoot the issue
Tools you may need:
Phillips head screwdriver
1.
Power cycle your machine by unplugging it and plugging it back in. Check if the console is able to turn on
If it will not turn on, please visit
troubleshooting.
2.
Disconnect your machine from power again and plug it back in. Listen for a clicking noise inside the machine as soon
as it is plugged back in. If a clicking noise is heard,
3.
Check that the pedals can move freely. If they cannot, please visit
it move? to continue troubleshooting.
4.
If the issue persists, remove the lower right fan shroud. Watch the video below or follow the instructions starting in th
next step.
5.
Use a Phillips head screwdriver to carefully loosen the bottom screw by at least 3 turns and remove the 3 upper screw
attaching the cover. The power plug wire inlet is attached to the inside and needs to be gently unplugged before
completely removing the cover (reference 1). It may help if you tilt the machine gently to the side to loosen the
bottom screw.
about:blank
Max Trainer M6:  Why is my resistance not changing?
Max Trainer M6: Why is there no power to my machine or console?
Bow ex® Max Trainer | Removing Lower Right Fan Shroud Bow ex® Max Trainer | Removing Lower Right Fan Shroud
(BowFlex® Max Trainer | Removing Lower Right Fan
[11193.B]
order a Servo Motor
Max Trainer M6: My machine is seized, why won't
ID: 11193.1
to continue
.
Shroud)
[11193.A]
1/4