Bowflex Max Trainer M8 Troubleshooting Manual

3/11/24, 8:48 AM
Max Trainer M8: Why is there no power to my machine or console?
Follow this troubleshooting guide to help resolve issues involving lack of power on the Max Trainer M8.
Some common complaints may include:
Buttons do not respond/aren't working
Console does not light up
Console lights up then turns off
Console only lights up partially
Please note: if you are using the BowFlex JRNY app on a mobile device or tablet while using your machine, the console will be
disabled. This is normal behavior.
Follow these steps to troubleshoot the issue
Tools you may need:
5mm hex/Allen wrench, or the Allen wrench from the
hardware card included with your machine
Phillips head screwdriver
1.
Power cycle your machine by unplugging it from power and plugging it back in. Let the console sit for 5 minutes.
the 5 minutes are complete, power cycle again and wait another 5 minutes. The console needs several minutes to boo
up after a firmware update
[11254.B]
Console
2.
If the console does not light up and the firmware was not recently updated, check to see if the display will light up at
all. Remove the protective film from the console display if you have not already done so
only turns on partially or flickers/is dim, please
partially? to continue troubleshooting.
3.
Briefly interrupt power to the machine by unplugging the power adapter from the power inlet (reference 1) about
halfway and immediately reinserting
order a Console
about:blank
Max Trainer M8:  Why is there no power to my machine or console?
[11254.A]
. If the console will not boot up after the firmware update,
.
[11254.D]
[11254.E]
.
visit Max Trainer M6, M8: Why does the console only light up
. If the console turns on after the power interruption, it is damaged -
(Reference 1)
ID: 11254.1
order a
[11254.C]
. If the console
Afte
1/4