Bowflex IC Bike SE Quick Start Manual

3/11/24, 4:53 PM
BowFlex IC Bike SE: Power Issues
Common issue descriptions:
Console/display does not light up
Console/display lights up partially
No power to the machine
Machine does not turn on/power on
Tools used in this guide:
crank puller
Estimated time to complete:
Let's get started!
We will check each of the components below (in order) to determine which is causing the issue.
1.
Check the Console Status LED light
2.
Check the external connections
Power cord, inlet, and wall outlet
Cable connection behind the console
3.
Cable connection at the Base Hub
Check the Console Status LED
The back side of your machine's console is equipped with a
with diagnosing issues during troubleshooting:
If the Status LED is ON and BLINKING:
The console software is updating and may take several minutes to
complete [15648.A].
If the Status LED is ON and SOLID:
The console may be asleep - press any button to wake your machine.
If your machine was recently plugged in, it may take approximately three minutes for the console to fully boot-up
[15648.B].
If the Status LED is OFF:
Power is not reaching the console -
Continue troubleshooting in the next section below.
Check the external connections
Tools Required:
None
Power flows through three cables before reaching the console. We'll power cycle your bike while we check each of the
connection points located outside your machine's shrouds.
Power Cord connections:
1.
Gently unplug the power cord from both the front of your machine and the electrical outlet.
about:blank
Phillips head and flathead screwdrivers, 15mm wrench, 16mm socket and wrench, 25mm
Approximately 35 to 40 minutes - two people may be required when checking cables.
do not replace the console!
Estimated Time to Complete:
5 minutes
BowFlex IC Bike SE: Power Issues
red LED status light to help
ID: 15648.5
Steps 1 - 2
1/4