Bowflex VeloCore 22 Quick Start Manual

3/7/24, 11:46 AM
VeloCore 22: Why won't my seat stay in place?
Common issue descriptions:
Seat slides down the post
Seat doesn't stay in place
Seat slips or drops down during workout
Tools used in this guide:
Estimated time to complete:
Let's get started!
We will check each of the components below (in order) to determine which is causing the issue.
1.
Seat adjustment handles
Seat assembly
Seat post
2.
Seat post and seat post sleeve
Check the seat adjustment handles
Tools Required:
None
Tighten the seat assembly adjustment handle
1.
Check the seat adjustment handle below the seat to see if it is fully tightened.
2.
If needed, tighten the adjustment handle:
a.
Rotate the handle counterclockwise to tighten the seat on the seat post.
b.
Once fully tightened, pull down on the adjustment handle and rotate the handle to
point behind the bike.
c.
Release the handle.
d.
Test if the issue persists [11862.A].
3.
If the issue persists, check the next component in the section below.
Tighten the seat post adjustment handle
1.
Check the seat post adjustment handle on the front of the seat post to see if it is fully
tightened.
2.
If needed, tighten the adjustment handle:
a.
Rotate the handle counterclockwise to tighten the seat post in the frame.
b.
Once fully tightened, pull the adjustment handle out (away from the seat post) and
rotate the handle to point downward.
c.
Release the handle.
d.
Test if the issue persists [11862.B].
3.
If the issue persists, check the next component in the section below.
about:blank
VeloCore 22:  Why won't my seat stay in place?
Isopropyl alcohol wipes, 32mm open-ended or adjustable wrench, flathead screwdriver
5 to 15 minutes
Estimated Time to Complete:
Less than 5 minutes
Service Manual Procedure:
Adjustments
ID: 11862.2
Steps 1 & 2
Steps 1 & 2
1/3