Video Loss Setting - Sanyo MPX-CD163 Instruction Manual

ALARM SET SETTINGS
Use the cursor button to move the
6
cursor to the middle of the screen,
– +
and then press the setting buttons
so that "A" is displayed.
Set so that "A" is displayed in the middle of
the screen.
------
----
--
CAMERA NO.05 T-1 LEVEL:OFF MODE:A
7
Use the cursor button to select "T-1", and then
press the setting buttons to select "T-2".
CAMERA NO.05 T-2 LEVEL:OFF MODE:A
8
Use the cursor button to select LEVEL "OFF", and
then specify a sensitivity of "2" with the setting
buttons.
CAMERA NO.05 T-2 LEVEL:2
9
Use the cursor button to select "MODE", and then
press the setting buttons to select "A".
CAMERA NO.05 T-2 LEVEL:2
Press the MENU button.
10
This completes the setting. The display
MENU
will return to the camera image screen.
When an intruder comes into the middle
of the camera 5 image, an alarm will be
generated.
A
2
2
MODE:A
2
MODE:A

VIDEO LOSS setting

(default setting: OFF)
If the camera image disappears because of a sudden accident
or some other reason (so that image input stops), this sets
whether the image that appeared immediately before the signal
was lost is displayed as a still image or whether a test pattern is
displayed.
Example: To set a test pattern for the image
when there is a VIDEO LOSS
1
Press the MENU button, use the cursor button to
select "ALARM SET" and then press the NEXT
button.
The ALARM SET screen will be displayed.
Use the cursor button to select
2
VIDEO LOSS "OFF", and then use
– +
the setting buttons to change to
"TEST".
Display examples:
OFF: When the video signal is lost, a blank screen is
displayed.
FREEZE: The image displayed immediately before the video
signal was lost is displayed as a still image.
TEST: When the video signal is lost, a test pattern is
displayed.
Note:
If no cameras are connected, "NO VIDEO" is displayed.
In this case, the video loss operation does not occur.
However, if the power is turned off when a video signal is
being input, the condition immediately before the video signal
was lost is detected and video loss operation occurs.
A still image or a test pattern is displayed during video loss
operation, but the recording device will record a test pattern
until the alarm is reset or the image returns to normal.
Even if a still image is set to be displayed during video loss
operation, a test pattern will appear if the screen is switched
or automatic switching display has been set.
Press the MENU button.
3
MENU
– 68 –
ALARM SET-8
(ALARM SET)
ALARM OFF
ACTIVE REC. OFF
MOTION SENSOR OFF
VIDEO LOSS TEST
ALARM SET-8
English