Sanyo VCC-HD2100 User Manual page 114

After installing the lens to the camera, you need to perform the following adjustments for the lens.
A
Focus Adjustment (FOCUS ASSIST)
B Flange Back Adjustment
C Iris Adjustment (IRIS)
Using network operation, you can use the focus assist function to adjust the focus.
You may also configure the back focus position switching mode to automatically adjust the back
focus position when switching between the color and black-and-white video modes.
(This function is supported only by VCC-HD2300P/VCC-HD2300)
Use the focus assist function to accurately focus on subject in high-resolution megapixel image because otherwise
doing so would be extremely difficult.
If you are using a varifocal lens, adjust the focus using the following procedure.
If the focus assist function does not work properly because the camera produces too dark or too
bright video images, perform iris adjustment
The focus must be readjusted if the camera has lost focus due to difference in the subject distance or
ambient temperature, the deterioration of the lens and installation environment, and the like that have
been caused over the years.
1
Press the SET button for 2 seconds or more.
The monitor now shows the SELECT MENU screen.
On the SELECT MENU screen, all information is displayed in English.
2
Select [FOCUS ASSIST] using the NEAR/FAR button and press the SET button.
The monitor now shows the focus adjustment screen.
3
Use the zoom lever of the lens to adjust the angle of view and the focus lever of the lens
to set the FA bar (
When the subject comes into focus, the color of the status indicator (
If the use of the focus lever does not provide precise focusing, follow the "Fine-adjusting focus" procedure
described below.
) to the maximum level.
A
C in advance.
B ) "FOCUSING" turns from black to orange.
Introduction 13/17