Sanyo VCC-HD2100 User Manual page 54

The terminal will not accept subsequent alarm signals until the set duration expires.
The alarm state will be retained for at least 5 seconds even if the motion is instantaneous.
The configured duration value will be reset to the factory default value if you change any setting on
the ALARM SETTINGS screen while an alarm state is retained.
To switch the alarm detection method, in [MOTION ALARM], click the desired radio button.
3
Drag the mouse over live video/image to select the detection area.
You can set up to five detection areas.
Each detection area will be given a number (1 to 5) as you add it. The currently selected area is shown in yellow
green.
To move a detection area, select it and then drag the mouse.
To resize a detection area, place the mouse pointer over its border and then drag the mouse.
To delete a set detection area, click the
number or drag it out of the screen.
4
In [AREA], select the check box next to the area number of the area you want to enable.
You may select two or more check boxes.
DELETE 1
button ( ) corresponding to the detection area
Working with Administrator Configuration Screens 35/50