Sanyo VCC-HD2100 User Manual page 106

This indicator lights up when the camera is powered on.
The indicator blinks while the firmware is being updated.
Use these terminals to connect a 24 VAC or 12 VDC power supply. The power indicator lights up when the camera
is powered on.
For details, refer to the "Basic Connections" section.
Use this socket to connect the camera to your PC to enable network operation.
For details, refer to the "Basic Connections" section.
Right: Link access indicator (Green)
This indicator lights up approx. 3 seconds after power on, if a connection has been established
between the camera and the network.
After that, it will blink when data are being transmitted via the network.
Left: Speed indicator (Orange)
The camera automatically detects the local network transmission speed (10BASE-T or 100BASE-
TX).
This indicator lights up when 100BASE-TX data transmission is in progress; it goes out when
10BASE-T data transmission is in progress.
For the detailed connection procedure, refer to the "Alarm Input/Output Terminal Connections" section.
Alarm input or Day/Night switching terminals (ALARM IN1/2)
1
These input terminals can be used for either of the following purposes:
Alarm input
Introduction 5/17