Atdec 2250 Installation Manual

2250 Tilt Pan VESA Wall Mount
COMPONENT CHECKLIST
TH-2250-VTP
(Fully assembled)
IMPORTANT INFORMATION
! Please ensure this product is installed as per these installation instructions.
! The manufacturer accepts no responsibility for incorrect installation.
! Failure to install this product correctly may cause serious injury/death during or following installation.
! This product is not suitable for outdoor use.
! Do not use this product for mobile applications.
! This product should only be installed by professional installers of good mechanical aptitude, who have experience with
building construction, and fully understand these instructions and the consequences of incorrect installation.
! Professional installer to ensure adequate structural capacity of wall (including appropriate safety factor) to support total
weight of all equipment being mounted.
! Drilling into electrical wires can cause death - use appropriate equipment and caution when drilling holes in walls to avoid
electrical cables, water pipes and gas pipes. Do not drill into structures unless you have established it's safe to do so.
! Curved monitors, deep devices (such as all-in-one PCs), VESA mounted accessories (such as mini PC brackets and mounts),
and offset VESA locations exert additional leverage that can exceed the capacity of the mount even though the monitor
weight may be within the stated range. Please contact Atdec if you would like further information.
A
Wall Mount
Screw (x2)
C D
M4 Washer M5 Washer
(x4) (x4)
F H
M4x8mm / M5x8mm /
G I
M4x12mm M5x12mm
(x4 each) (x4 each)
B
Nylon
Anchor (x2)
E
M6 Washer
(x4)
J L
M6x8mm / M8x8mm /
K M
M6x12mm M8x12mm
(x4 each) (x4 each)
Installation Guide
TH-2250-VTP
REQUIRED TOOLS
• Power drill
• Suitable drill bit
• Driver bit for selected
wall fasteners
• Stud finder
• Spirit level
• Phillips Head Screwdriver
CAPACITY
0 - 30kg
(0 - 66lbs)
TH-2250-VTP Page 1 of 3