Installing Your Camera
3. Connect the safety wire (attached to the camera) to the surface mount as
shown. Then, arrange the cables. (For more information about the wiring,
refer to "Camera Wiring(18 Page)".)
SAFETY-WIRE
4. Arrange the cables inside the surface mount so that they should not be
entangled or stuck in, and align the guide rib of the camera with that of the
surface mount. Use the L-shaped wrench to tighten the screws (x4) so that
the camera is secured to the mount. To ensure waterproofness, take caution
lest that the outer gasket should get loose or be stuck in.
SURFACE MOUNT
MAIN-FRAME
GASKET
38
SPEED DOME CAMERA
Guide Rib of SURFACE
MOUNT
Guide-Rib of MAIN-
FRAME
SCREW
User Guide
SCP-3120V (mount onto the optimal adaptor)
1. Follow step 1 in "Ceiling Mount" above and remove the surface mount.
2. Insert the cables into the cable hole on the surface mount and fix them to
SBP-302F (HANGING MOUNT) using SCREW-MACHINE (BH, M4xL10, x4).
3. Repeat step 3 through step 4 in "Ceiling Mount" above to complete the
installation.
SPEED DOME CAMERA
39
User Guide