Sears PRO-FORM CROSS WALK 2.5 User Manual page 8

DIAGRAM OF THE CONS0"LE
BATI'ERY INSTALLATION
The console requires three "AA" batteries (not In-
cluded). Alkaline batteries are recommended.
To install battedes, open the battew cover under the
console as shown below. Press three batteries Into the
batte_j com-
p_tment.
Make sure
that the neg-
ative (-)
ends of the
batteries are
touching the
springs.
Close the
battery cover.
STEP BY STEP CONsoLE oPERATION
Before operating the console, make sure that the power
cord Is properly plugged In. (See HOW TO PLUG IN
THE POWER CORD on page 7.) If there is a thin sheet
of clear plastic on the face of the console_ remove it.
Next, step onto the foot mils of the treadmill. Rnd the
clip attached to the key (see the drawing above), and
slide the clip onto the waistband of your clothing.
Follow the steps on page 9 to operate the console.