Table of Contents
Advertisement
Chapter 9
Cycle Pick/Place
The Cycle Pick/Place test picks a cartridge from the element you specify
and places it back in the same element. The test repeats the number of
times you specify. To run the Cycle Pick/Place test:
1. From the Diagnostics Menu, press >@ or >@ to select Cycle
2. Press >@ and >@ to select the element index (shown in the upper
3. Press >(QWHU@. The library displays the following screen:
4. Press >@ and >@ to select the number of cycles, in increments of ten,
5. Press >(QWHU@. The CHM picks and replaces the cartridge the number
122
Pick/Place and press >(QWHU@. The library displays the following
screen:
S e t
S o u r c e
↑
I n c r e a s e
↓
D e c r e a s e
right corner) of the cartridge slot where you want the CHM to pick
and place the cartridge.
S e t
C y c l e s
↑
I n c r e a s e
↓
D e c r e a s e
that you want the Cycle Pick/Place test to run.
of times you specified.
0
1 0
Scalar AIT 440/480
Advertisement
Table of Contents
