Table 16 Network Configuration Fields - Quantum DXi3500 User Manual

Table 16 Network
Configuration Fields
Field Description
DHCP Enable or disable DHCP on the specific DXi3500/DXi5500 port (port 1 or port 2).
IP Address View or set the IP address for the DXi3500/DXi5500 system.
View or set the network mask for the DXi3500/DXi5500 system
Network Mask
View and set the link speed and duplex for the DXi3500/DXi5500 system (10/100/
Link Speed &
Duplex
half/full/auto)
Port Gateway
Network
Netmask
Gateway
Quantum DXi3500 and DXi5500 User's Guide
The is a static route that can configured for this interface.
Port Gateway
It is optional. If you want to configure a route, you must specify all
three fields (
Network
View and set the
Network Addres
subnet of the static IP address.
View and set the
Network Mask
View and set the
Gateway
3 In the section, select the port you wish to associate to the
General
default gateway.
4 Edit the default gateway, host, and domain information as desired.
5 Click .
Apply
Note: If the system has DHCP enabled and cannot receive an IP
address from the DHCP server, the system will reset back
to the default IP address (10.1.1.1 for port 1 and 10.0.1.0 for
port 2). If the port is DHCP enabled, the DHCP server
provides the default gateway, domain name, and DNS IP
address, even though the user has entered values for these
fields.
Caution: If NAS shares exist on this system and you change the
network information, the system will reboot. Ensure
that there are no backups running before changing the
network information.
Chapter 3 DXi3500 and DXi5500 Remote Management
, , and
Netmask Gateway
s of this route. Normally, it is the
for this route.
IP address for this route.
Configuration
).
65