Audio Connections - Pioneer Elite PRO-1010HD Operating Instructions Manual

Installation and Connections

Audio connections

Before making connections, be sure to check that the
audio component's power and the unit's main power is
off.
Connecting the speakers
This unit is equipped with a 7W + 7W internal amplifier. If
speakers are to be connected to the unit, following the
accompanying connection instructions.
Notes
÷ After connecting the wires, pull gently on the cables to confirm
that the wire cores are fastened securely in their terminals.
Insecure connections will result in noise or interrupted sound.
÷ Do not allow the wire cores of the ª and · speaker cables to
protrude excessively, since they may touch each other,
causing a short circuit. This will produce excessive load on the
plasma display, causing operation to malfunction or stop.
Making connections to the audio inputs on this
unit
This unit features four audio inputs. The following chart
shows the video inputs and the corresponding audio input
terminals.
Video
Audio input jacks
input
1
INPUT1 Pin jacks (L/R)*
INPUT2 Pin jacks (L/R)
2
INPUT3 Pin jacks (L/R)*
2
INPUT4 Pin jacks (L/R)*
INPUT5 Pin jacks (L/R)
1
* The audio input jack is the same for INPUT1 D-sub and
HDMI.
2
* The audio input jack is the same for INPUT3 and
INPUT4.
18
EN
Twist exposed
wire strands
together.
Push tab to the open
position, and insert the
wire. Then, close tab
firmly to secure the wire
in place.
Sound output
Sound of the selected video
input is output from the
SPEAKER (L/R) terminals.
Audio connection for component connected to
INPUT1 (D-sub or HDMI)
AUDIO
INPUT1
INPUT1
R L
The audio line for the component connected to D-sub or
HDMI INPUTs of INPUT1 can be connected to the AUDIO
R/L (INPUT1) pin jacks.
Sound is output from the SPEAKER (L/R) terminals
according to the video input selection.
Note
When using HDMI analog audio, set AUDIO to ANALOG (or
AUTO) (Please see page 27).
Audio connection for component connected to
INPUT2
AUDIO
INPUT2
R L
The audio line for the component connected to INPUT2
can be connected to the AUDIO R/L (INPUT2) pin jacks.
Sound is output from the SPEAKER (L/R) terminals
according to the video input selection.
Note
When using AUDIO INPUT2, set the AUDIO to ANALOG (or
AUTO) (Please see page 27).