Pioneer Elite PRO-1010HD Operating Instructions Manual page 7

About operations in this manual
Each operation is described in its proper operating order.
These Operating Instructions will refer to the operating
controls found on the remote control unit, with the
exception of those buttons found only on the main
plasma display itself. When the plasma display controls
include equivalent buttons to those found on the remote
control unit, the commands can be performed on the
main unit as well.
The following illustrations are an example of the actual
operations used for the section "PICTURE adjustment".
The examples are provided to allow you to confirm
whether the operation is performed correctly or not.
Picture and Screen Adjustment
Picture Adjustment (1)
You can save picture adjustment setting values for each
INPUT and each AV SELECTION mode.
Display operating
panel
1
Press the AV SELECTION button to select the
desired mode (Refer to page 33).
2
Press the MENU button to display the menu.
3 Use the 5/∞ buttons to select the item, then press
the SET button.
MENU
5/∞
MENU
2/3
2/3
SET
SET
5/∞
AV
SELECTION
Remote control unit
STANDARD INPUT1
PICTURE SCREEN SETUP OPTION
CONTRAST :
0
:
BRIGHTNESS 0
:
COLOR 0
:
TINT 0
:
SHARPNESS 0
MPEG NR : MID
:
DNR MID
:
CTI ON
PICTURE RESET
SET ENTER MENU EXIT
STANDARD INPUT1
PICTURE SCREEN SETUP OPTION
CONTRAST :
0
:
BRIGHTNESS 0
:
COLOR 0
:
TINT 0
:
SHARPNESS 0
MPEG NR : MID
:
DNR MID
:
CTI ON
PICTURE RESET
SET ENTER MENU EXIT
Note
The screen images depicted in these Operating Instructions
should be considered typical images; some difference will be
seen in practice, depending on the screen item displayed and its
contents, the input source and various other control settings.
4 Use the 2/3 buttons to adjust picture quality to
the desired setting.
:
SR + MODE CONTRAST : 0
ON
SET SET MENU EXIT
5
Press the SET button.
Adjustment values are saved, and you return to the
display shown in step 3.
6
After completing settings, press the MENU button
to return to the normal display.
¶ Adjustment and setting items during video signal input
Decrease Increase
CONTRAST ... Contrast becomes weaker Contrast becomes stronger
BRIGHTNESS ... Picture becomes darker Picture becomes brighter
COLOR ........ Colors become weaker Colors become stronger
TINT ............. Skin tones become purplish Skin tones become greenish
SHARPNESS ... Picture becomes softer Picture becomes sharper
MPEG NR
Use when there is mosquito noise in the picture when
viewing a digital broadcast, playing a DVD etc.
Each time you press the 2/3 buttons, the setting
changes as follows:
3 OFF 2 3 LOW 2
3 MID 2
3 HIGH 2
¶ As you change from LOW 3 MID 3 HIGH, the effect
becomes stronger.
DNR
This function reduced graininess to provide a clearer
picture.
Each time you press the 2/3 buttons, the setting
changes as follows:
3 OFF 2 3 LOW 2
3 HIGH 2 3 MID 2
¶ As you change from LOW 3 MID 3 HIGH, the effect
becomes stronger.
CTI
This lets you brighten color contour as desired.
Each time you press the 2/3 buttons, the setting
changes as follows:
3 OFF 2
3 ON 2
¶ ON .... CTI is operating.
¶ OFF ... CTI is not operating.
Before Proceeding
35
EN
3
EN