Pioneer Elite PRO-1010HD Operating Instructions Manual page 29

Set [SIGNAL FORMAT] and [COLOR DECODING] as follows.
Please take care when making settings. Incorrect settings
can adversely affect the plasma display.
SETUP
Connected
component
Component video output 480p
of a DVD player, etc.
Component video output 720p
from digital tuner, etc.
RGB video output of a 480p
video deck etc., with RGB
output
RGB video output of a PC VGA, WVGA,
720-PC,
XGA, WXGA
9
Press the SET button.
This completes [COLOR DECODING] setting, and
returns you to the display shown in Step 7.
10
After completing settings, press the MENU button
to return to the normal display.
[CLAMP POSITION] setup
(INPUT1 (D-sub), 5)
Depending on the signal, analog RGB signals may result
in the screen image appearing with a whitish or greenish
cast. In such cases, set [CLAMP POSITION] to [LOCKED].
Normally, leave this setting at [AUTO].
MENU
5/∞
2/3
SET
Display operating panel
1
Press the MENU button to display the menu screen.
STANDARD
PICTURE SCREEN
CONTRAST
BRIGHTNESS
COLOR
TINT
SHARPNESS
MPEG NR
DNR
CTI
PICTURE RESET
ENTER
SET
SIGNAL COLOR
FORMAT DECODING
COMPONENT
COMPONENT
RGB
Not supported
MENU
2/3
SET
5/∞
Remote control unit
INPUT1
SETUP OPTION
:
0
:
0
:
0
:
0
:
0
:
MID
:
MID
:
ON
EXIT
MENU
2 Use the 2/3 buttons to select [SETUP].
STANDARD
PICTURE SCREEN
PURECINEMA
CLAMP POSITION
SIGNAL FORMAT
COLOR DECODING
HDMI INPUT
BRT. ENHANCE
3 Use the 5/∞ buttons to select [CLAMP POSITION]
then press the SET button.
STANDARD
PICTURE SCREEN
PURECINEMA
CLAMP POSITION
SIGNAL FORMAT
COLOR DECODING
HDMI INPUT
BRT. ENHANCE
4 Use the 2/3 buttons to select [LOCKED].
C L A M P P O S I T I O N
SET SET
The factory default setting is [AUTO].
Each time you press the 2/3 buttons, the setting
changes as follows:
3 AUTO 2
3 LOCKED 2
5
Press the SET button.
This completes [CLAMP POSITION] setting, and
returns you to the display shown in Step 3.
6
After completing settings, press the MENU button
to return to the normal display.
Notes
÷ Make this [CLAMP POSITION] setting individually for INPUT1
(D-sub) or INPUT5.
÷ When using this setup, be sure to carefully check the signal
output of the component that you are using. For details, please
refer to the instruction manual supplied with the component
you are connecting.
Setting HDMI
(INPUT1 (HDMI), 2)
Perform setting after completing HDMI connection to
either INPUT1 or INPUT2.
Follow the procedures below and make settings as they
apply to the type of components connected.
Notes
÷ Perform HDMI setting individually for INPUT1 or INPUT2.
Remember that for INPUT1, setting is possible only when
[HDMI] is selected with [INPUT1 SELECT].
÷ Setting is not possible when INPUT1 (D-sub), or INPUT3
through INPUT5 are selected.
System Settings
INPUT1
SETUP OPTION
:
OFF
:
AUTO
:
480p
:
RGB
:
ON
INPUT1
SETUP OPTION
:
OFF
:
AUTO
:
480p
:
RGB
:
ON
: LOCKED
MENU EXIT
25
EN