Others - Pioneer Elite BDP-23FD Operating Instructions Manual

Problem
07
Software updating is slow.
• "WRT NG ****" is displayed
on the front panel display
during software updating.
(**** meaning any
characters)
• "WRT FAILED" is displayed
on the front panel display
during software updating.
A message other than
"Network connection test
completed successfully" is
displayed when Connection
Test is performed.

Others

Problem
The player's power turns off
automatically.
The player's power turns on
automatically.
Player cannot be operated
with remote control.
Input of connected TV and AV
system switches
automatically.
"Processing failed." is
displayed.
62
En
Check
Is "LAN cable not connected"
displayed?
• Is "IP address cannot be
obtained." displayed?
• Is "No response from the
gateway." displayed?
Is "IP address is overlapped."
displayed?
Is the Ethernet hub (or router
with hub functionality)
operating properly?
Check
Is Auto Power Off set to
On?
Is Display Power Off set to
On?
Is KURO LINK set to On?
Is an AV receiver or amplifier
connected to the CONTROL
IN terminal on the player's
rear panel?
Are you operating the remote
control from a point too far
away from the player?
Are the batteries dead?
Is KURO LINK set to On?
Remedy
Depending on the Internet connection and other conditions, some time
may be required to update the software.
The message is displayed when software updating has failed. Check
again whether it can be updated properly.
Check that this player and Ethernet hub (or router with hub
functionality) are properly connected.
• If the IP address is obtained using the DHCP server function, check
the setting is correct at the Display Network Configuration
(page 44). For details on the DHCP server function, see the operating
instructions of the Ethernet hub (or router with hub functionality).
• Set the IP address manually.
• Check the operation and settings of the DHCP server function of the
Ethernet hub (or router with hub functionality). For details on the DHCP
server function, see the operating instructions of the Ethernet hub (or
router with hub functionality).
• If this player's has been set manually, reset the IP address of this
player or other components.
• Check the settings and operation the Ethernet hub (or router with hub
functionality). For details, see the operating instructions of the Ethernet
hub.
• Reboot the Ethernet hub (or router with hub functionality).
Remedy
If Auto Power Off is set to On, the player's power turns off
automatically if no operation is performed for over 30 minutes
(page 41).
The player's power may turn off together with the power of the TV
connected to the HDMI OUT terminal. If you do not want the player's
power to turn off when the TV's power is turned off, set Display Power
Off to Off (page 39).
The player's power may turn on together with the power of the TV
connected to the HDMI OUT terminal. If you do not want the player's
power to turn on when the TV's power is turned on, set KURO LINK to
Off (page 39).
Operate with the remote control of the device connected to the
CONTROL IN terminal.
Operate from within 23 feet (7 m) of the remote control sensor.
Replace the batteries (page 7).
The input of the TV and AV system (AV receiver or amplifier, etc.)
connected to the HDMI OUT terminal may automatically switch to the
player when playback starts on the player or the menu screen (Home
Media Gallery, etc.) is displayed. If you do not want the inputs of the
connected TV and AV system (AV receiver or amplifier, etc.) to switch
automatically, set KURO LINK to Off (page 39).
If the message appears repeatedly, please ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.