Table of Contents
Advertisement
2
Select and set the method for switching the
speaker to be adjusted.
Use / to select, then press ENTER.
• Auto – Switch the speaker to be adjusted
automatically.
• Manual – Switch the speaker to be adjusted
manually.
3
Adjust the output level.
Use / to select, / to adjust.
Channel Level
BD PLAYER
L
0.0 dB
C
0.0 dB
R
0.0 dB
SR
0.0 dB
SBR
0.0 dB
SBL
0.0 dB
SL
0.0 dB
SW
0.0 dB
Note
• You can also adjust while listening to the sound being
played (page 35).
• The volume of the test tones output from the
subwoofer may seem lower than the tones output
from the other channels. Adjust the subwoofer based
on the sound during playback (page 35).
• When Auto is selected, the speaker cannot be
selected with
/. In this case, test tones are not output from the
subwoofer.
Setting the IP address
Select and set Network IP Address Next
1
Screen.
Use / to select, then press ENTER.
2
Set IP address.
Use /// to set the IP address of the player or DNS
server, then press ENTER.
Network
BD PLAYER
IP Address
Auto Set IP Address
IP Address
Subnet Mask
Default Gateway
Auto Set DNS Server Address
DNS Server (Primary)
DNS Server (Secondary)
• Auto Set IP Address
On – The player's IP address is obtained
automatically. Select this when using a broadband
router or broadband modem that has a DHCP
(Dynamic Host Configuration Protocol) server
function. This player's IP address will automatically
be allocated from the DHCP server.
Off
Off
Off – The player's IP address must be set manually.
Use the number buttons (0 to 9) to input the IP
address, subnet mask and default gateway.
• Auto Set DNS Server Address
On – The DNS server's IP address is obtained
automatically.
Off – The DNS server's IP address must be set
manually. Use the number buttons (0 to 9) to input the
DNS server's IP address stipulated by your Internet
service provider.
Note
• When Auto Set IP Address is set to Off, Auto Set
DNS Server Address is also set to Off.
• For information on DHCP server function, refer to the
network device's operating instructions.
• You may need to contact your Internet service
provider or network administrator when inputting the
IP address manually.
Setting the proxy server
Only set the proxy server if so instructed by your Internet
service provider.
Select and set Network Proxy Server Next
1
Screen.
Use / to select, then press ENTER.
2
Select and set Use or Not use at Proxy Server.
Use / to change, then press .
Network
BD PLAYER
Proxy Server
Proxy Server
Server Select Method
Server Name
Port Number
• Use – Select this when using a proxy server.
• Not use – Select this when not using a proxy server.
If you have selected Use, proceed to step 3.
3
Select and set Server Select Method.
Use / to change, then press .
• IP Address – Input the IP address.
• Server Name – Input the server name.
4
Input IP Address or Server Name.
Use the number buttons (0 to 9) to input the number if you
select IP address by step 3. Use / to move the cursor.
Use the number buttons (0 to 9) to input characters if you
select Server Name by step 3.
The characters that can be input for the server name are
listed on the table below. Pressing a button repeatedly
cycles through the characters shown.
Use
Server Name
06
43
En
Hide quick links:
Advertisement
Table of Contents
