Panasonic Toughbook CF-F9KWH011M Reference Manual page 176

Troubleshooting (Advanced)
Windows XP
Click [Start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] - [Device Manager].
Double-click [PCMCIA adapters], and double-click the relevant device.
B
In [Resources], if [Conflicting device list] shows [No conflicts], there is no conflict.
Read the instructions supplied with the PC Card, or consult the PC Card manufacturer.
Check that you are using a driver supported by the operating system.
You do not know the available RAM module
Refer to "Expanding Memory" (
Microsoft Windows Logo Authentication is not obtained
If "This driver is not digitally signed!" message is displayed, the driver you attempt to install may not have obtained
Microsoft Windows Logo Authentication. Consult the peripheral manufacturer.
To check if the additional RAM module has been installed successfully
If the installation is successful, the main memory and total RAM module size appears in the [Information] menu of the
Setup Utility ( page 149).
If the RAM module is not confirmed:
• Turn the computer off and reinsert the RAM module.
• Confirm the recommended specifications.
Regarding the RAM module, refer to "Expanding Memory" (
The address map for IRQ, I/O port address, etc. is unclear
You can check with the following procedure.
Windows 7
A
Click (Start) - [Computer] - [System properties] - [Device Manager].
Windows XP
Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] - [Device Manager].
Click [View] - [Resources by type].
B
page 93).
page 93).
176