Panasonic KX-HCM250 Operating Instructions Manual page 75

Over write setting:
Selects [Over Write...] to overwrite the transferred image or [Add
time...] to save each transferred image.
Data transfer method:
Use [Passive Mode] normally. If FTP does not work properly, ask your
ISP or network administrator about the transferring mode of FTP
server. [Passive Mode] or [Active Mode] is available.
b.
Mail: Sets the SMTP and POP3 server address*
Login ID*
From (Reply)*
same address as From (Reply).
To * : Enter the e-mail address of receiver.
3
Subject & Text *
Time in 24 h mode is attached on the subject.
Notes
• Set POP3 server address or Host Name, Login ID and
Password if you need POP authentication to send the e-mail.
Ask your ISP or administrator.
• Network Camera will only operate correctly with SMTP (Simple
Mail Transfer Protocol) server. It is not available with Internet-
accessed mail servers like "Hotmail
accessed via web browser.
c.
Select [No Message] or [Mail]
Mail: Only the notification e-mail is sent when the alarm trigger is
active. Refer to b. Mail for each parameter.
* Refer to IP addressing on page 104.
1
* Refer to unavailable character set 1 on page 104.
2
* Refer to unavailable character set 2 on page 104.
3
* Only ["] is unavailable in the ASCII character table on page 104 and
4
refer to displayable character set on page 105.
2.
Select/Enter the each parameter. Click [Save] when finished.
• Click [Cancel] to quit the current settings. The window returns to Setup
Page without saving the parameters.
• Click [Clear Buffered images] to clear the buffered image.
[Clear Buffered images] does not save the parameters.
[For assistance, please call: 1-800-272-7033]
and Password*
2 2
: Enter the e-mail address of [Reply-to]. [To] can be the
3
: Sets the subject and text of the e-mail.
4
.
" or other mail accounts
®
Operating Instructions
or Host Name* ,
1 2
75