Panasonic KX-HCM250 Operating Instructions Manual page 119

Problem
Green indicator
continues
blinking.
Orange
indicator
continues
blinking.
Red indicator
continues
blinking.
Image Transfer
on e-mail or FTP
does not work.
Timer mode
transfers older
images.
Wireless
communication
does not work.
Wired
communication
does not work.
About Network Camera Setup
Internal Failure of the server or the congestion on the network
traffic when using DHCP may prevent Network Camera from
getting the IP address. Ask the network administrator or your ISP.
Orange indicator blinks when updating firmware on page 91. When
the Update Firmware failed, refer to page 120.
If you cannot access Network Camera, the Network Camera
hardware may be defective. Call our customer call center.
• Default Gateway and DNS server address should be set up on
Network window on page 58.
• If FTP does not work properly, ask your ISP or network
administrator about the transferring mode of FTP server.
[Passive Mode] or [Active Mode] is available.
• Select [One Time] for Login Timing when transferring images
by FTP in short duration time.
Short interval of Image Buffer Frequency makes Network Camera
transfer the older images. Set the interval long enough to transfer
the images. Buffered Image screen enables you to check this
setting.
• Signal strength is weak. Change the location of Network
Camera or get rid of the obstacle around Network Camera.
• SSID and Encryption setting of Network Camera are different
from those of the wireless router or the wireless LAN card of
PC. SSID and Encryption setting must be identical between
Network Camera and wireless router.
• Draw out the Ethernet cable and reconnect the AC adaptor for
Network Camera to recognize the Wireless Communication
mode.
Reconnect AC adaptor for Network Camera to recognize the
change from wireless to wired communication or vice versa.
[For assistance, please call: 1-800-272-7033]
Cause and Remedy
Operating Instructions
119