InterPuls milkrite Orbiter User Instruction Manual page 12

1530170_2023.08_EN
7 MAINTENANCE
Requirements for storage
Keep all components away from direct sunlight and any equipment that produces high concentrations of
ozone.
Cleaning
Orbiter claws (all ranges) are required to be adequately cleaned after every milking routine.
This should be done in accordance with industry standard recommendations, ensuring the routine is followed
with the correct cleaning solution concentrations, temperatures and durations.
Periodical maintenance
Spare part reference Description
--
S001
(service kit)
S002
(service kit)
S003
(service kit)
NOTE
Inspect all components for signs of damage and/or wear at regular intervals.
Replace damaged parts immediately using only original milkrite | InterPuls spare parts.
After replacements a pre-washing routine is required to remove any impurity.
The user retains responsibility for correct installation and maintenance.
Please contact your local milkrite | InterPuls dealer or sales representative for assistance if
required.
This manual is the property of InterPuls S.p.A. - any copying, even partial, is strictly prohibited.
Orbiter claws (all ranges) Clean
Small Gasket
Bowl Gasket
Shut-off valve
Locking valve cap
Small Gasket
Bowl Gasket
Small Gasket
Bowl Gasket
Shut-off valve with
Stainless Steel Pin
Locking valve cap
Action Interval
Every milking routine
Replace Once a year or 4.500 operating hours
12
Original instructions