Table of Contents
Advertisement
Chapter 8
Setting ISDN Primary Rate Annex Values
Annex Manager User Guide
8-14
Understanding the T1/PRI Line Box
The
box displays information in the
T1/PRI Line
box uses only the
Type
•
defines the kind of switch the ISDN Primary Rate
Switch Type
Annex uses. The value you select here depends on the switch
provided by your telephone company. You can select:
•
for AT&T's 5ESS switch.
5ESS
•
for the switch that supports National ISDN2.
NI-2
•
for Nortel's DMS100 switch.
DMS100
•
to set the switch value to a null string (" ").
Default
The
window selects the
T1/PRI Line
current
settings:
Switch Type
•
is selected if
Default
window. If you do not choose another setting, the
T1/PRI Line
ISDN Primary Rate Annex you selected will use
in the United States,
Australian lines.
•
displays as selected if the Annex you chose is operating
Other
outside the United States. This setting indicates that the switch
type is set to
ETS
commands to check these values.
The
box allows you to configure the FDL standard. It describes
FDL Type
the facilities data link use. This allows the telephone company to read the
statistics maintained by an Annex and to perform diagnostic tests. There
are four choices:
•
none
•
att
•
ansi
•
Other
buttons.
Switch Type
and
Default
Other
is not set when you first use the
Switch Type
for European lines, and
ETS
or
. You can use CLI admin
ETS-AUS
Part 2
Setup Mode
box. The
Switch Type
Switch
buttons based on
for lines
5ESS
for
ETS-AUS
Advertisement
Table of Contents
