Chapter 2-Hardware Installation; Introduction; Safety Warnings; Hardware Installation Procedures - Multitech ISI9234PCIE User Manual

Introduction

This chapter describes installation of the Multi-Tech ISI as an expansion card in your PCI-bus computer.

Safety Warnings

•
This product must be installed by a qualified service person.
•
When installing or servicing this product, the phone lines must be disconnected to remove the risk of
hazardous voltages.
•
Never install telephone wiring during a lightning storm.
•
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
•
This product is to be used with UL and CUL listed computers.
•
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at
the network interface.
•
Use caution when installing or modifying telephone lines.
•
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk
of electrical shock from lightning.
•
Do not use the telephone to report a gas leak in the vicinity of the leak.

Hardware Installation Procedures

To install the ISI Card into your PCI-bus computer, follow the steps presented below.
1. Turn off your computer and any peripheral equipment connected to it. The ISI Card can be installed in a
Pentium equivalent PCI bus computer.
2. Remove the cover of your computer as instructed in your computer's documentation.
3. Before handling the ISI Card, discharge any static in your body by touching a piece of grounded metal
such as the computer chassis.
4. Carefully remove the ISI Card from its antistatic bag, handling it only by the mounting bracket and edges.
Do not touch the gold-plated connectors along the bottom edge. (You may want to save packaging for
possible future use.)
Chapter 2—Hardware Installation
ISI5634UPCI-8
ISI9234PCIE-8
Chapter 2 – Hardware Installation
7