Table of Contents
Advertisement
IDE Devices Configuration
Press <Enter> to enter the sub-menu and the following screen appears:
On-Chip IDE Controller
The integrated peripheral controller contains a IDE interface with support for two IDE
channels. Select [Disabled] to disable the integrated IDE controller, [Primary] to enable
only the primary IDE controller, [Secondary] to enable only the secondary IDE controller,
or [Both] to enable both IDE controllers. Setting options: [Disabled], [Primary],
[Secondary], [Both].
PCI IDE BusMaster
Set this option to [Enabled] to specify that the IDE controller on the PCI local bus has
bus mastering capability. Settings options: [Disabled], [Enabled].
I/O Devices Configuration
Press <Enter> to enter the sub-menu and the following screen appears:
OnBoard Floppy Controller
Select [Enabled] if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it.
Option
Description
[Enabled]
Enables the onboard Floppy controller.
[Disabled]
Disables the onboard Floppy controller.
COM Port 1
This item specifies the base I/O port addresses of the onboard Serial Port 1 (COM 1).
Selecting [Auto] allows AMIBIOS to automatically determine the correct base I/O port
address. Settings: [3F8/IRQ4], [2F8/IRQ3], [3E8/IRQ4], [2E8/IRQ3] and [Disabled].
Parallel Port
This field specifies the base I/O port address of the onboard parallel port. Selecting
[Auto] allows AMIBIOS to automatically determine the correct base I/O port address.
Settings: [378], [278], [3BC] and [Disabled].
BIOS Setup
3-13
Hide quick links:
Advertisement
Table of Contents
