Target LORING Quick Start Manual page 2

Make sure the cam bolts have been screwed down flush and not left partially inserted.
STEP 1:
Place H and I parallel to each other on a flat surface and attach F and G to the ends with eight
H3 using H9.
Do not fully tighten the bolts.
STEP 2:
Place A upside down on a flat surface and attach with the finished assembly from the previous
step with four H2, six H4 and two H7.
Fully tighten cam bolts, do not fully tighten bolts and screws.
WARNING
For use with televisions weighing 50 pounds (22.7 kg) or less.
Use with heavier televisions may result in instability causing tip over resulting in death or serious
injury.
Use of anti-tip restraints may only reduce, but not eliminate, the risk of tip-over.
STEP 3:
On the underside of A, attach D with two H6.
Fully tighten cam locks.
STEP 4:
Attach B to the middle rungs of G and F and bottom of D with four H1, two H8 and two H7.
Fully tighten cam bolts, do not fully tighten bolts and screws.
STEP 5:
On the underside of B, attach E with two H6.
Fully tighten cam locks.
STEP 6:
Attach C to the bottom rungs of G and F and the bottom of E with four H1 and two H8.
Do not fully tighten bolts and screws
PLEASE NOTE: Barrel Nuts are pre-installed. Barrel Nuts may need adjusting to properly align
holes of Barrel Nuts with Bolts.
STEP 7:
Attach J and H to the finished assembly with four H3, three H4 and four H5.
Apply firm pressure to align and fully tighten all bolts and screws.
STEP 8:
Level the TV stand accordingly.
WARNING
Please make sure that all objects are removed before moving the assembled unit.
The unit must be team lifted, not dragged or pushed.
Failure to do so could cause instability, product collapse, and / or serious injury.
WEIGHT LIMITS
Top panel: 50 lbs.
Shelf: 25 lbs.