Summit Client - LXE MX7 Reference Manual

Wireless Zero Config Utility

Summit Client

The WZC utility has an icon in the toolbar that looks like networked computers with a red X
through them, indicating that Wireless Zero Config application is enabled and the MX7 is not
connected to a network. LXE does not recommend use of the Wireless Zero Configuration Utility
for configuring the client as it cannot be used to configure all supported security protocols.
You can use either the Wireless Zero Configuration Utility or the Summit Client Utility to connect
to your network.
LXE recommends using the Summit Client Utility to manage the client device.
To use Wireless Zero Config, first open the Summit Client Utility.
1. Select ThirdPartyConfig in the Active Config drop down box.
2. A message appears that a Power Cycle is required to make settings activate properly. Tap
3. Tap the Disable Radio button to remove the connection to the Summit Client Utility. The
4. Tap the Power button to place the MX7 in Suspend, then tap the Power button to wake
The Wireless Zero Config utility begins.
E-EQ-MX7RG-H
OK.
text on the button changes to Enable Radio.
the MX7 from Suspend mode.
.
MX7 Reference Guide
279