Changing the lithium-ion battery
This digital camera uses one NP-200 lithium-ion battery. Before using the battery, read the safety
warnings on pages 3 and 4 of this manual. When replacing the battery, the camera should be turned
off.
Slide the battery-chamber door toward the bottom of the camera to
release the safety catch (1). Open the door (2).
Move the battery latch towards the back of the camera to
insert the battery (3). Slide the battery into the battery cham-
ber (4) with the battery terminals first until it is caught by the
latch.
To remove the battery, move the latch towards the back of
the camera until the battery is released (5). Pull the bat-
tery out of the chamber (6).
Close the battery-chamber door (7) and slide it toward
the top of the camera to engage the safety catch (8).
• After installing the battery, the set-time/date message
may appear on the monitor. The clock and calendar is
set in the setup 1 section of the menu (p. 18). An
internal battery protects the clock, calender, and
memory settings for more than 24 hours if the camera
is used for at least 5 minutes before removing the
battery.
4
6
3
5
7
8
2
1
13