JVC DR-M10S Instructions Manual page 30

30
EN
TV
MUTING
GHI
PQRS
DBS
CANCEL
VCR Plus+
TOP MENU
MENU
PREVIOUS
SLOW
REC
REC MODE LIVE CHECK
SET UP DISPLAY ON SCREEN
AUDIO SUBTITLE ANGLE
CABLE/DBS
TV DVD
STANDBY/ON
TV/
TV/CBL/DBS DVD
VIDEO
TV VOLUME
ABC DEF
JKL MNO
CH
TUV WXYZ
AUX MEMO/MARK
PROG/CHECK REC LINK TIMER
NAVIGATION
rtwe
ENTER
ENTER
RETURN
NEXT
PLAY/SELECT SLOW
CLEAR
STOP/ PAUSE
OPEN/
CLOSE
PROGRESSIVE
SCAN
INITIAL SETTINGS (cont.)
Setting cable box's brand and channel
After installation, set the cable box's brand and channel
correctly; otherwise, the Controller cannot work
correctly.
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/DBS/DVD switch to DVD.
A
Turn on the cable box.
Turn on the cable box's power.
B
Access the Main Menu screen.
Press SET UP.
C
Access the "CABLE BOX SET" screen.
A Press w e to move the
arrow to "INITIAL SET
UP", then press ENTER.
B Press w e to move the
arrow to "STB SET", then
press ENTER.
C Press rt to move the
arrow to "CABLE BOX
SET", then press ENTER.
D
Select the cable box's channel.
Your selection depends on
how the cable box is
connected to your unit.
A Press rt to move the
arrow to "CABLE BOX
OUTPUT CH", then press
ENTER.
B If the cable box is
connected to your unit's ANTENNA IN connector on
the rear panel, press rt to select the channel
number representing the cable box's output (CH2 –
CH9), then press ENTER.
If the cable box is connected to your unit's AUDIO/
VIDEO INPUT connectors on the rear panel, press
rt to select "L-1" or "L-2", then press ENTER.
If you do not use a cable box, press rt to select
"OFF", then press ENTER.