Installing Your New Unit; Basic Connections - JVC DR-M10S Instructions Manual

Jvc dr-m10s: instruction manual
Hide thumbs Also See for DR-M10S:
Table of Contents

Advertisement

18
EN

Basic Connections

Matching transformer
(not supplied)
AUDIO/VIDEO
ANTENNA
OUTPUT
IN
IN
Y
VIDEO
S-VIDEO
P
B
LEFT
OUT
P
AUDIO
R
RIGHT
COMPONENT
ANTENNA
OUTPUT
ANTENNA
OUT
Audio/video cable
(supplied)
RF cable
(supplied)
To 75 ohm
Terminal
TV
Antenna or Cable
Coaxial cable
Flat feeder
AC Outlet
AC Power Cord
L-1
L-2
S-VIDEO
VIDEO
LEFT
L-1
PCM STREAM
AV COMPU LINK
AUDIO
DIGITAL OUT
L-2
RIGHT
CABLE BOX
OPTICAL
COAXIAL
INPUT
Back of unit
To Audio/video
input connectors
It's essential that your unit be properly connected.
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
A
Check the contents.
Make sure the package contains all of the accessories
listed in "SPECIFICATIONS" on page 109.
B
Install the unit.
Place the unit on a stable, horizontal surface.
C
Connect the unit to a TV.
A Disconnect the TV antenna from the TV.
B Connect the TV antenna cable to the ANTENNA IN
connector on the rear panel of the unit.
C Connect the supplied RF cable between the
ANTENNA OUT connector on the rear panel of the
1
unit and the TV's antenna connector.
D Connect the supplied audio/video cable between the
AUDIO/VIDEO OUTPUT connectors on the rear
panel of the unit and the TV's audio/video input
connectors.
Set your TV to AV mode.
For switching the TV's mode, refer to the instruction manual of
your TV.
D
Connect the unit to power source.
Plug the end of the AC power cord into an AC outlet. This
unit performs Plug & Play Set automatically. (
The clock and tuner channels will automatically be set when
the antenna is connected and when the AC power cord is first
connected to an AC outlet. (If "AUTO" and the channel
indicator are displayed on the front display panel before the
unit is powered on, the clock and tuner channels are being set
automatically. Wait for the time to be displayed on the front
display panel before turning on the unit.)
NOTES:
It requires the RF connection to enjoy TV programs.
The playback image is not displayed without one of the
following: A/V, S-Video, or Component Video connection.

INSTALLING YOUR NEW UNIT

pg. 21)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dr-m10

Table of Contents