Table of Contents
Advertisement
Shooting
Time Code Recording
Setting (continued)
Presetting the Time Code/User's Bit
The time code and user's bit can be set in the [TC/UB] menu.
(A Page 69)
There are two ways to display the [TC/UB] menu.
A
Display the menu screen using the [MENU/THUMB]
button, then select the [TC/UB] menu. (A Page 58)
B
Assign the TC/UB function to a user button and press
the button. ( A Page 19, 66 )
* Set [Main Menu]B[Camera Function]B[Switch
Set]B[USER1]/[USER2]/[LOLUX/3]/[C.REVIEW/4]/
[ZEBRA/5]/[REC/6] to TC/UB . (A Page 66)
Setting the time code
1
Use the method above to display the [TC/UB] menu.
2
Set the run mode of the time code generator.
Set [TC Generator] to Rec Run or Free Run .
(A Page 69)
● Rec Run :The time code operates in the run mode only
during recording.
● Free Run :The time code operates in the run mode at all
times.
3
Set the framing mode of the time code generator.
Set [Drop Frame] to Non Drop or Drop . (A Page 69)
● Non Drop
: The time code generator operates in the
non-drop frame mode. Use this setting when
placing emphasis on the number of frames.
● Drop
: The time code generator operates in the
drop frame mode. Use this setting when
placing emphasis on the recording time.
Memo :
● Drop cannot be set when [Record Format]B[Frame &
Bit Rate] in the [Record Set] menu is set to 50, 25, or 24.
4
Select [TC Preset] and press the center of the set
lever.
The time code preset screen appears.
[TC Preset] Screen
(During drop frame)
5
Set the time code (hour, minute, second, frame).
● Push the set lever up or down to change the setting value.
● Push the set lever to the left or right to jump to the next digit.
Memo :
● Press the [USER2] button to set all digits to "0".
6
Confirm the time code setting.
● Press the center of the set lever.
● Returns to the [TC/UB] menu.
Closing the menu screen
1
Press [MENU/THUMB].
The normal screen is displayed.
MENU/
THUMB
Presetting the user's bit
1
Select [UB Preset] in the [TC/UB] menu. (A Page 69)
The method for setting the user's bit is the same as the
method for setting the time code.
An alphanumeric character between 0 to 9 and A to F can be
specified for each digit.
Cursor
During non-drop frame
Advertisement
Table of Contents
