I Unpacking; I Antenna Jumper Cable Connection; I Selecting A Location; I Rack Mounting Handle Attachment - Icom IC-7800 Instruction Manual

2
INSTALLATION AND CONNECTIONS

I Unpacking

I Antenna jumper cable connection

I Selecting a location

I Rack mounting handle attachment

After unpacking, immediately report any damage to the
delivering carrier or dealer. Keep the shipping cartons.
For a description and a diagram of accessory equip-
ment included with the IC-7800, see 'Supplied acces-
sories' on p. iii of this manual.
Connect the supplied coaxial cable (terminated with
BNC connectors) between [RX ANT A— IN] and [RX
ANT A— OUT], and, [RX ANT B— IN] and [RX ANT
B— OUT], respectively.
When connecting an external filter unit, pre-amplifier,
etc., connect the unit between [RX ANT A/B— IN] and
[RX ANT A/B— OUT] connectors.
Select a location for the transceiver that allows ade-
quate air circulation, free from extreme heat, cold, or
vibrations, and away from TV sets, TV antenna ele-
ments, radios and other electromagnetic sources.
The base of the transceiver has an adjustable stand
for desktop use. Set the stand to one of two angles de-
pending on your operating preference.
Remove the four screws from both sides of the front
panel and the two screws from both sides of the side
panel, then attach the rack mounting handles to the
sides of the transceiver using the supplied screws.
2-2