Icom IC-7800 Instruction Manual page 130

I Fine programmed scan/fine ∂F scan
[F-1•PROG] [F-2•∂F] [F-3•FINE] [EXIT/SET]
In fine scan (programmed or ∂F), the scan speed de-
creases when the squelch opens, but the transceiver
keeps scanning. The scanning tuning step shifts from
50 Hz to 10 Hz when the squelch opens.
q Push [EXIT/SET] several times to close a multi-func-
tion screen, if necessary.
w Push [F-5•SCAN] to select the scan screen.
e Set for programmed scan or ∂F scan as described
on previous page.
r Push [F-1•PROG] or [F-2•∂F] to start a scan.
• "
blink while scanning.
t Push [F-3•FINE] to start a fine scan.
• "
instead of "
tively.
y When the scan detects a signal, the scan speed de-
creases but scan does not stop.
u Push [F-1•PROG] or [F-2•∂F] to stop the scan; push
[F-3•FINE] to cancel the fine scan.
• Rotating the main dial also cancels the scan.
i Push [F-6•RECALL] for 1 sec. to recall the fre-
quency that is set before starting the scan, if de-
sired.
9-5
SCANS
" or " " and decimal points
" or "
" or "
9
" blinks
," respec-