Downloading Firmware And Fonts - Datamax M-Class Mark II M-4206 Operator's Manual

Datamax operator's manual printer m-4206
Hide thumbs Also See for M-Class Mark II M-4206:
Table of Contents

Advertisement

5.8 Downloading Firmware and Fonts

The operating programs and fonts for the printer are stored in Flash memory on the Main PCB. When program updates
and/or new features are added, they can be downloaded to the printer as follows:
1. Identify the new version for your model of printer from the Datamax Web site at
it onto your computer's hard drive or a floppy disk.
2. Ensure that the printer is connected to the host, (via parallel port only) and that the power is 'On.' Using the DOS copy
command enter:
copy filename.dlf lpt1/b
Note: Other programs (e.g., hyper-terminal and certain Windows Driver programs) may also be used to download this file.
3. The
light will flash during the download.
READY
4. Following a successful download, the
previous printer setup will not be affected unless substantial firmware data structure changes have occurred. Print a
Database Configuration Label to verify your new firmware version.
Following an unsuccessful download, the
reset' (both the
READY
remain operational. If the printer fails to reset, toggle the power 'Off' and 'On.'
Try re-sending the file to the printer. If the failure continues, check the following possible causes:
An invalid or corrupted file is being downloaded - Ensure the file being downloaded is correct and applicable
for your printer model.
Possible communications error - Check the cable connection between the host and printer and ensure that a
quality, shielded cable is used.
Possible Flash memory problem - Call for service.
If the printer fails to boot-up after an unsuccessful download, turn 'Off' the power. Simultaneously press and hold
the
+
PAUSE
44
STOP
and
lights will be on during power-up initialization). The original firmware will
STOP
buttons while powering 'On' the printer. Now, try downloading the file to the printer.
CANCEL
Light will illuminate then the printer will perform a 'cold reset.' The
Light will illuminate then the printer will perform a 'warm
ERROR
www.datamaxcorp.com
and download
M-4206

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents