Datamax M-Class Mark II M-4206 Operator's Manual page 35

Problem
Label Alignment is
incorrect. Pressing
successively
FEED
results in a label length
longer than actual, one-
inch.
Tear Mode is selected
but the label stop
position (present
position) is not far
enough forward.
Tear Mode is selected
but the label stop
position (present
position) is too far
forward.
The light
ERROR
illuminates during label
alignment.
M-4206
Possible Cause
Label Alignment Length is
not correct. The default
Label Alignment Length is
1.00", and will result in
this behavior when any
larger label length is used
without setting the
appropriate length
Another present position
has been determined.
Enabling the Present
Sensor causes the label
stop position (present
position) to be
approximately 0.1" behind
the peel bar.
~OR~
The Present Adjust value
is not correct.
Another present position
has been determined.
~OR~
The Present Adjust value
is not correct.
The label supply is empty
Solution
Set Label Alignment to AUTO. Press and hold
paper moves for automatic Label Alignment length
measurement.
~OR~
Measure the label length and use the Setup Menu to set the new
length. Print a Database Configuration label to ensure the new
length has been set.
Disable the Present Sensor.
~OR~
Ensure the host computer is not providing a Present Distance
shorter than is required for the Tear Bar.
Use the Setup Menu to modify the Present Adjust value.
Ensure the host computer is not providing a Present Distance
longer than is required for the Tear Bar.
Use the Setup Menu to modify the Present Adjust value.
Load media.
until
FEED
29