Wi-Fi Pairing Via Ap Hotspot; Environment Setup; Wi-Fi Pairing Steps; Enabling Ap Mode - Quectel FCM360W Pairing Manual

2

Wi-Fi Pairing via AP hotspot

2.1. Environment Setup

1. One FCM360W-TE-B development board
2. PC: connect the development board to the PC and check the corresponding COM port in the "Device
Manager".
3. AP router: launch 2.4GHz hotspot
4. Mobile phone
5. QCOM tool

2.2. Wi-Fi Pairing Steps

2.2.1. Enabling AP mode

Step 1: Press the RESET button on the FCM360W-TE-B to reboot the module.
Step 2: After the module is rebooted, execute AT+QSOFTAP=<SSID>[,<key>] to enable the AP mode of the
module. For example, execute AT+QSOFTAP="FCM360W","12345678" to set the name of the
module AP hotspot to "FCM360W" and password to "12345678".

2.2.2. Connecting to AP Hotspot

Connect your mobile phone or PC to the AP hotspot of the module and check the current AP gateway. For example,
you can check the current AP gateway on the mobile phone:
4 / 6