Download
Share
Print this page
Craftmade Utility Installation Manual
  1. Manuals
  2. Brands
  3. Craftmade Manuals
  4. Fan
  5. Utility
  6. Installation manual

Craftmade Utility Installation Manual

Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
Utility
Installation Guide
For Model:
UT56TBNK3MR
UT56WW3MR
net weight of fan: 11.68 lb (5.3 kg)

Table of Contents:

Wiring. pg. 6
Warranty. pg. 8
page 1
READ THESE INSTRUCTIONS AND
AND SAVE THEM FOR FUTURE USE
PRINTED IN CHINA

Advertisement

loading
Need help?

Need help?

Do you have a question about the Utility and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Craftmade Utility

Summary of Contents for Craftmade Utility

  • Page 1: Table Of Contents

    READ THESE INSTRUCTIONS AND AND SAVE THEM FOR FUTURE USE Utility Installation Guide For Model: UT56TBNK3MR Table of Contents: Safety Tips. pg. 2 UT56WW3MR Unpacking Your Fan. pg. 3 Parts Inventory. pg. 3 Installation Preparation. pg. 4 Hanging Bracket Installation. pg. 4 Fan Assembly.

  • Page 2: Safety Tips

    Distributed by: Craftmade, 3901 S. 20th Avenue, DFW Airport, TX, 75261; 1-800-486-4892 NOTE: The important safety precautions and instructions appearing in the manual are not meant to cover all possible conditions and situations that may occur.

  • Page 3: Unpacking Your Fan

    1. Unpacking Your Fan. Carefully open the packaging. Remove items from Styrofoam inserts. Remove motor housing and place on carpet or Styrofoam to avoid damage to finish. Do not discard fan carton or Styrofoam inserts should this fan need to be returned for repairs. Check against parts inventory that all parts have been included.

  • Page 4: Installation Preparation

    3. Installation Preparation. blade edge To prevent personal injury and damage, ensure that the hanging location allows the blades a clearance inches 10 feet of 10 ft. (3.048 m) from the floor and 30in. (76cm) 3.048 m) (76 cm) from any wall or obstruction. This fan is suitable for room sizes up to 12ft.

  • Page 5: Fan Assembly

    5. Fan Assembly. Loosen canopy set screw and lower canopy to expose hanging bar. Separate electrical wiring and safety cable from rubber band. Lift fan onto j-hook hanging bracket and slide rubber bushing over hook. Make the wiring connections as shown in Section 6 on j-hook the following page.

  • Page 6: Wiring

    wall control wire 6. Wiring. wood joist from ceiling CAUTION: Be sure outlet box is properly grounded safety cable and that a ground wire (GREEN or Bare) is present. black white Make sure all electrical connections comply with Local wood screw and washer Codes or Ordinances and the National Electrical Code.

  • Page 7: Canopy Assembly

    8. Canopy Assembly. Lift canopy until it covers hanging bracket and touches ceiling. Tighten canopy set screw to secure canopy. 9. Blade Assembly. canopy canopy set screw WARNING: To reduce the risk of serious bodily injury, DO NOT use power tools to assemble the blades.

  • Page 8: Testing Your Fan

    11. Testing Your Fan. CRAFTMADE LIMITED LIFETIME WARRANTY: It is recommended that you test fan before CRAFTMADE warrants this fan for use as intended under finalizing installation. Restore power from the following provision: CRAFTMADE will replace any fan circuit box. Test fan speeds with wall which has faulty performance due to a defect in material control.

This manual is also suitable for:

Ut56tbnk3mrUt56ww3mr