Subscribe to Our Youtube Channel
Related Manuals for Shark POWERDETECT IP3000 Series
Summary of Contents for Shark POWERDETECT IP3000 Series
- Page 1 POWERDETECT Clean & Empty ™ Cordless Vacuum IP1000 Series IP3000 Series OWNER’S GUIDE...
-
Page 2: Important Safety Instructions
Pre-motor filter, and soft roller in place. substances, or flammable dust) and fire. Only use Shark® branded filters and Turn off the vacuum before plugging in or Disconnect the battery pack from the accessories. Failure to do so will void unplugging the charger. - Page 3 AUTO-EMPTY ASSEMBLY (IP3000) NON-AUTO-EMPTY ASSEMBLY (IP1000) 1. Slide the Wand onto the neck of the Floor 4. Place the dock on the floor near a wall 1. Slide the Wand onto the neck of the Floor For proper operation, ensure all components Nozzle until it clicks into place.
- Page 4 ODOR NEUTRALIZER TECHNOLOGY ODOR NEUTRALIZER TECHNOLOGY ADJUSTING THE ODOR INTENSITY ODOR CARTRIDGE REPLACEMENT 1. REMOVE ODOR DIAL 2. REMOVE OLD ODOR FROM THE AUTO-EMPTY DOCK CARTRIDGE ODOR DIAL Flip up the handle and rotate the dial clockwise Rotate the cartridge counterclockwise in Flip up the dial handle and rotate the odor dial until the two arrows are aligned.
-
Page 5: Li-Ion Battery
NOTE: When the unit is docked properly, the charging lights on the battery will blink, indicating that charging has begun. NOTE: The Shark battery, like all lithium-ion batteries, will naturally decrease in capacity over time from the 100% NOTE: The main unit comes with a partial charge. For maximum runtime, charge fully before first use (approximately capacity of a new battery. -
Page 6: Battery Removal
BATTERY REMOVAL USING YOUR VACUUM REMOVING THE BATTERY CONTROLS AND CLEANING MODES POWER UPRIGHT BATTERY When upright, the nozzle will lock to allow Press the button on the control screen for freestanding storage when the hand vac to turn on power. To turn off power, press To remove the battery from the hand vacuum, is detached. -
Page 7: Above-Floor Cleaning
ABOVE-FLOOR CLEANING MAINTAINING YOUR VACUUM EMPTYING THE DOCK DUST BIN ABOVE-FLOOR WITH HAND VACUUM ABOVE-FLOOR WITH WAND Detach the hand vacuum to clean above-floor To detach the floor nozzle from the wand, areas. Press the front latch release button on step on the nozzle while pressing the nozzle release button at the bottom of the hand vac where it meets the wand, then lift... - Page 8 USING YOUR VACUUM MAINTAINING YOUR VACUUM USING THE AUTO-EMPTY DOCK CLEANING THE HEPA FILTER (IP1000 SERIES) NOTE: Rinse the HEPA filter at least once a month to maintain suction power. More frequent cleaning may be necessary with heavy use. To clean the filter, rinse it with water only and allow it to air-dry completely for up to 48 hours before reinstalling.
-
Page 9: Cleaning The Sensors
MAINTAINING YOUR VACUUM MAINTAINING YOUR VACUUM CLEANING THE SENSORS CLEANING THE AUTO-EMPTY DOCK FILTER Make sure to clean the Detect sensors Fig. 1 regularly, as hair and other debris may build up and obstruct them. If the sensors are Air path partially obstructed, DETECT mode will not function as expected. -
Page 10: Troubleshooting
MAINTAINING YOUR VACUUM MAINTAINING YOUR VACUUM CHECKING FOR BLOCKAGES IN THE VACUUM TROUBLESHOOTING If you run over a hard or sharp object or notice a noise change while vacuuming, check for WARNING: To reduce the risk of shock and unintended operation, turn off blockages or objects caught in the brushroll. -
Page 11: Five (5) Year Limited Warranty
ADDITIONAL ACCESSORIES AVAILABLE ON SHARKACCESSORIES.COM Crevice Tool FIVE (5) YEAR LIMITED WARRANTY Duster Crevice Tool Flexible Crevice Tool The Five (5) Year Limited Warranty applies to purchases made from authorized retailers of SharkNinja Anti-Allergen Brush Operating LLC. Warranty coverage applies to the original owner and to the original product only and is not transferable. -
Page 12: Technical Specifications
1. Product Name: Odor Neutralizer Cartridge not transferable. Model Number: ����������������������������� 2. Manufacturer: Shark Ninja 89 A Street, SharkNinja warrants that the unit shall be free from defects in material and workmanship for a period Date Code: ��������������������������������� Needham, MA 02494 of two (2) years from the date of purchase when it is used under normal household conditions and maintained according to the requirements outlined in the Owner’s Guide, subject to the following... - Page 13 This product may be covered by one or more U.S. patents. See sharkninja.com/patents for more information. © 2024 SharkNinja Operating LLC. SHARK and MULTIFLEX are registered trademarks of SharkNinja Operating LLC. FLOOR DETECT, LIGHT DETECT, and POWERDETECT are trademarks of SharkNinja Operating LLC.
Need help?
Do you have a question about the POWERDETECT IP3000 Series and is the answer not in the manual?
Questions and answers
How do I print the manual for series 3000 shark vacuum?