Power Supply; Main Serial Interface - Datalogic DS4800 Reference Manual

4
To avoid electromagnetic interference when the scanner is connected to a
CBX connection box, verify the jumper positions in the CBX as indicated in
its Installation Manual.
NOTE

4.1 POWER SUPPLY

Power can be supplied to
as shown in Figure 21:
The power must be between 10 and 30 Vdc only.
It is recommended to connect the device CHASSIS to earth ground (Earth) by setting the
appropriate jumper in the CBX connection box. See the CBX Installation Manual for details.

4.2 MAIN SERIAL INTERFACE

Do not connect to the Main Interface spring clamp terminals if using Host
Interface Modules (Fieldbus) with t
CAUTION
The signals relative to the following serial interface types are available on the CBX spring
clamp terminal blocks.
If the interface type is not compatible with the c
s ystem forces the handshake to none.
The main interface type and the relative parameters (baud rate, data bits, etc.) can be
set using the Genius™ utility program or the Genius™ based Host Mode Programming
p rocedure.
D etails regarding the connections a
38
the scann er through
Power Supply
VGND
V+ Earth
in Groun d
Figure 21 - Power Supply Connections
he CBX500.
nd use of the interfaces are given in the next paragraphs.
DS4800 REFERENCE MANUAL
the CBX100/500 spring clamp terminal pins
urrent communication handshaking, then the