One Cable TV Box or Digital Cable
Receiver (NTSC)
Connect the NTSC TV signal source from the standard
cable TV set-top box or digital cable receiver (sold
separately) into the HP Digital Entertainment Center.
If you are using a standard set-top box or digital cable
receiver with S-video or composite video output, do the
following:
1
Make sure that a coaxial cable connector from your
cable TV source (wall) is plugged into the set-top box
or digital cable receiver In connector.
2
Connect a video cable:
a
Choose a video out connector:
Coaxial (RF)
■
Video (composite)
■
S-video
■
b
Connect the video cable from the set-top
box or digital cable receiver back panel Video
Output connector.
c
Connect the video cable into the HP Digital
Entertainment Center back panel TV Source 1 In
connector.
3
Connect stereo audio cables (skip this step if using
coaxial [RF]):
a
From the set-top box or digital cable receiver
back panel Audio Out right (red) and Audio Out
left (white) connectors.
b
Into the HP Digital Entertainment Center back
panel TV Source 1 In Audio right (red) and Audio
left (white) connectors.
4
Connect the set-top box Infrared Transmitter cable
(required for signal). See "Infrared Transmitter
Connection" on page 97.
Connecting TV Source In
89