Infrared Transmitter Installation - HP z560 User Manual

Infrared Transmitter Installation

If you have a cable TV receiver, satellite receiver, or other
set-top box that controls your TV signal, connect the
Infrared Transmitter sensor:
1
Route the Infrared Transmitter cable from the back of
the HP Digital Entertainment Center to the cable TV,
digital cable, or satellite receiver set-top box.
2
Locate the IR remote receiver area on the front of the
set-top box. This is where you aim the set-top box
remote control to change channels, change the
sound level, and so on.
The IR remote receiver area may be behind an
■
obvious window on the set-top box.
Use the set-top box remote control to locate its IR
■
remote receiver area: Hold the remote control
very close (within 1 inch/2.54 centimeters) and
press a remote button to change the channel or
power off the box. As you push a button,
gradually move the remote control across the
front of the box until the box responds.
Hold a flashlight close to the front of the set-top
■
box, and look for a transparent window with a
small box inside. Test the area by holding the box
remote close to the window and pushing a button
until the box responds.
3
Use a piece of tape to temporarily hold the Infrared
Transmitter cable tip over the set-top box IR remote
receiver area while you test the function.
4
Plug the Infrared Transmitter cable into the Infrared
Transmitter connector on the back of the HP Digital
Entertainment Center.
5
Test the operation by pointing the HP Digital
Entertainment Center remote control at the HP Digital
Entertainment Center IR receiver and pressing a
channel button. (Be sure you use the HP Digital
Entertainment Center remote and point it at the
HP Digital Entertainment Center.)
6
For permanent attachment, remove the paper from
the Infrared Transmitter cable tip, and press the tip
onto the IR remote receiver area on the set-top box.
7
Repeat these steps for the second set-top box.
Connecting TV Source In
99