USB Device Connection
Digital Still Camera
The following instructions apply only to digital still
cameras.
When connecting a digital still camera, use a USB
connector on the front or back of the HP Digital
Entertainment Center.
To connect a digital still camera:
1
Turn on the HP Digital Entertainment Center. Wait
for the desktop to appear. Minimize or close
Media Center.
2
Turn on the digital still camera. See the
documentation that came with your camera.
3
Connect the camera transfer cable into the camera.
4
Connect the camera transfer cable into an open USB
connector on the front or back of the HP Digital
Entertainment Center. Most digital still cameras use
either the USB or FireWire (IEEE 1394) connector.
5
A Found New Hardware message displays. Wait
two or three minutes for the system to make the
necessary settings for the new device. When
installation is complete, a message displays telling
you the camera is ready to use.
On /Standby
HP Digital Entertainment Center
Digital still camera connection (front panel)
AUDIO OUT
AUDIO 7.1 PRE-OUT
SURROUND
SURROUND
CENTER
FRONT
BACK
L
L
L
L
100-240V- 4/A 50/60Hz
R
R
R
SUB
R
AC IN
WOOFER
COAXIAL
OPTICAL
DIGITAL
AUDIO
HI SPEED USB 2.0
1394
OUT
USB 2.0
Digital still camera connection (back panel)
Connecting the Network
USB 2.0
Digital
Camera
WIRELESS LAN
802.11 a/b/g
Y
REMOVABLE ANTENNA
ACTIVITY
LINK
Pb
TV SOURCE 1 IN
CABLE/ANT. IN FM ANTENNA IN
R
L
Pr
DUAL
75
Ω
AUDIO
VIDEO
S-VIDEO
TUNER
COAXIAL
TV SOURCE 2 IN
HDTV / SDTV ANT. IN
10/ 100/ 1000
R
AUDIO
L
S-VIDEO
ATSC TUNER
INFRARED TRANSMITTER OUT
2
1
ETHERNET
Digital
Camera
121