Floppy Drive - HP Visualize J280 Owner's Manual

Floppy Drive

The floppy disk drive ships with the drive set to SCSI ID
address 0. We recommend keeping the address setting at 0
unless it is used by another device.
CAUTION: Floppy disk drives are susceptible to mechanical
and electrostatic shock. When handling the drive,
always wear the static-grounding wrist strap that
came in the floppy disk drive kit. Always handle
the drive carefully.
If you need to change the floppy disk drive's address, follow
these instructions, referring to Figures B–11 and B–12. If you do
not need to change the drive's address, go to Step 10 of this
installation procedure.
1. Locate the jumpers on the top of the floppy drive.
2. To change the jumpers, use needlenose pliers to set the
drive's SCSI ID to an address that is not used by another
SCSI device. Check that the other jumpers are set correctly.
NOTICE: Do not use SCSI ID 7 for your floppy drive's
SCSI address. The host SCSI controller uses
SCSI ID 7.
3. Use needlenose pliers to remove the SCSI terminators, if
still attached to the drive.
B-21