HP Visualize J280 Owner's Manual page 93

5-6
Table 5–4. Problems Using a Hard Disk Drive
Problem Solution
The disk drive is not Make sure that all SCSI devices are
accessible or does set to the proper SCSI ID. (See Ap-
not respond. pendix C for default SCSI ID set-
tings.)
Check that all SCSI devices are cor-
rectly cabled. Check that the SCSI bus
is correctly terminated. (See Appendix
C for information on SCSI cabling
and termination.)
Make sure that the system can com-
municate with the drive as described
in "Checking the SCSI IDs" in Ap-
pendix B.
Follow the instructions in "Dealing
With a Boot Failure" later in this
chapter.
If problems persist, contact your system administrator or call
your designated service representative.