HP Visualize J280 Owner's Manual page 210

To display the current setting for a particular system path, follow the
directions in "Accessing the Boot Console Interface" earlier in this
appendix, and then type the following at the prompt:
Main Menu: Enter command > path path_type
where path_type is one of the path types listed in Table 5–8.
For example, to get the path to the primary boot device, follow the
directions in "Accessing the Boot Console Interface" earlier in this
chapter, and then type the following at the prompt:
Main Menu: Enter command > path primary
To set a system path to a new value, follow the directions in "Acces-
sing the Boot Console Interface" earlier in this chapter, and then type
the following at the prompt:
Main Menu: Enter command > path path_type path
where path_type is one of the path types listed in Table 5–8 and path
is the specification of the path in Mnemonic Style Notation (as de-
scribed in Table 5–9). For example, to set the primary boot path to a
SCSI disk with an ID of 6.0, follow the directions in "Accessing the
Boot Console Interface" earlier in this appendix, and then type the
following at the prompt:
Main Menu: Enter command > path pri sescsi.6.0
D-15